How To Clean Your Atomizers

Start by unscrewing your atomizer from the battery and grab a few tissues or some paper towel.  Wipe off the atomizer.  Put your lips on the battery end of the atty and blow air through the atty into the paper towel.  You will probably see brown liquid on the paper towel.  Repeat this process until little or no liquid is being blown into the towel.   After the cleaning process your atomizer will be very dry. It is important not to vape with a dry atomizer.  Now prime your atomizer by dripping four or five drops of your favorite e-liquid onto your dry atty and take a few puffs.  Add a few more drops of e-liquid and you should be ready to go.

Boiling Dirty Atomizers - When your atty starts getting a little worn out, and it just doesn't taste or hit like it used to, you can try boiling your atty in water on the stove. Use distilled water to avoid mineral deposits in the atomizer and keep the device from touching the pan where heat is applied. You only have to boil the atty for a few minutes, but be sure to use tongs because it will be very hot.  Let the atty dry on paper towel.  This may take several hours.  Do not run your atty under cold water.  Prime your atty with E-Liquid like mentioned above and you should be ready to go.  This might not restore your atomizer one hundred percent, but it will breathe some new life into your old atty.  Boiling your atomizer once every week or two will help keep the atomizer clean from buildup.

Soaking Atomizers in Alcohol - Another way to clean your atomizer is to let it soak in some grain alcohol overnight. Do not use rubbing alcohol as it may make you sick. When the atty is done soaking, let it set on a paper towel with the 510 threading up allowing the excess alcohol and particulate to drain out of the device. Leave it set for a few hours to dry completely. Once it is dry, prime the atomizer as you would when it is new with some PG or unflavored liquid. Allow enough time for the liquid to assimilate any excess alcohol, roughly 10 minutes. After blowing the atty out into a paper towel, you will be able to prime it with your favorite juice and vape!